I’m just about ready to start stitching my new hexie hummingbird design, and I thought I’d share how I take my hexies to-go with me so I can work on piecing anywhere!
I physically layout my whole design before starting to stitch. That means you need to have a layout space large enough for your project. The hummingbird is on the smaller side, so it fits on card table. For other projects I’ve used a 4′ x 8′ piece of foam insulation covered in batting and rested it on a table top.
Here’s how (get ready for a few photos!):
You’ll need • a long strip of batting about an inch wider than your hexie pieces, • a strip of fabric same size as the batting strip, and • a scrap of practice quilting
The scrap of practice quilting should be the same width as the fabric and batting. Roll it up and secure it with paper clips.
Next, start laying out a row of hexies – centered onto the piece of batting:
Continue lining up your hexies exactly as they are in the layout:
Leave a little space between separate rows, so you don’t accidentally sew them together.
When you run out of space, lay the strip of fabric over the hexies.
This piece of fabric will keep the hexies from sticking to the backside of the batting.
From here, take the pre-rolled quilted scrap and place it on the end where you just ended your layout. This piece will keep your hexies from getting bent in the roll.
Carefully roll it all up, adjusting the fabric strip as needed:
Now you can pin it on the sides to keep it all in place:
When your ready to stitch, place the roll in a small plastic container like this:
I put a spool of thread behind it for stabilization, because this roll is a little small for the container. O